This morning I drilled and tapped the exhaust port in the cylinder and cut the exhaust port in the valve face to depth. It is now ready for fitting the exhaust pipe when I get round to it.... Now I can enjoy my breakfast.
Shed Matters 3
-
Stanley
- Global Moderator
- Posts: 102569
- Joined: 23 Jan 2012, 12:01
- Location: Barnoldswick. Nearer to Heaven than Gloria.
Re: Shed Matters 3
This morning I drilled and tapped the exhaust port in the cylinder and cut the exhaust port in the valve face to depth. It is now ready for fitting the exhaust pipe when I get round to it.... Now I can enjoy my breakfast.
Stanley Challenger Graham
Stanley's View
scg1936 at talktalk.net
"Beware of certitude" (Jimmy Reid)
The floggings will continue until morale improves!
Old age isn't for cissies!
Stanley's View
scg1936 at talktalk.net
"Beware of certitude" (Jimmy Reid)
The floggings will continue until morale improves!
Old age isn't for cissies!
-
Stanley
- Global Moderator
- Posts: 102569
- Joined: 23 Jan 2012, 12:01
- Location: Barnoldswick. Nearer to Heaven than Gloria.
Re: Shed Matters 3
A good morning. I set up and bored the cylinder. When I did a few check measurements after boring to 1.5" it looks very good indeed. I shall verify that tomorrow. At the moment that was a good hour's work and I deserve my breakfast!
Stanley Challenger Graham
Stanley's View
scg1936 at talktalk.net
"Beware of certitude" (Jimmy Reid)
The floggings will continue until morale improves!
Old age isn't for cissies!
Stanley's View
scg1936 at talktalk.net
"Beware of certitude" (Jimmy Reid)
The floggings will continue until morale improves!
Old age isn't for cissies!