OneGuyFromBarlick

I'm going to have to give this one to you Kev, even though that isn't the full story. They are actually very specialised cutters for Ivory and were only used on Ornamental Turning Lathes.....
Next one?

What is it?

Dont know but it needs washing.........

Oh dear, I know we have had this one before

Oiling rag

Plumber's soldering mat?

Is it for wiping lead joints?

Sorry, nobody has it yet......

Clue, why the two cuts in one end of it?

If there are no takers by midday I'll knock it on the head but I am surprised it has survived. I would have thought Wendy would have known what it was....

Me?? I have no idea. Unless it's the wick for a paraffin heater.

There you are, I told you Wendy would know! Yes, it's a wick for a paraffin heater, used in brooders and and under sump heaters for cars in the old days.....
Next one?

What is it?

Door ??

No Tom, sorry.

The centre bit seems to have had some stick, is it part of a gate?

Is it the underside of something?

Gavel block ??

Is it part of an Anvil

Sorry, nobody is anywhere near. You need some clues. The bit you can see is about 4" X 3" and it's part of something not a lot bigger. The wear is due to its age. What can you think of that's made of a tropical hard wood and strengthened with brass?
I've seen the last two comments and no to both.

Printing block ??

Sorry Tom...... Another clue. Suppose this was a tool?

Is it an old rebate plane ??

Is it part of a pulley?

It's a good 'un. Puts me in mind of a family Bible binding - though I doubt it.