Page 120 of 120
Re: Shed Matters 3
Posted: 17 Nov 2025, 05:50
by Stanley
This morning I drilled and tapped the exhaust port in the cylinder and cut the exhaust port in the valve face to depth. It is now ready for fitting the exhaust pipe when I get round to it.... Now I can enjoy my breakfast.
Re: Shed Matters 3
Posted: 18 Nov 2025, 06:10
by Stanley
A good morning. I set up and bored the cylinder. When I did a few check measurements after boring to 1.5" it looks very good indeed. I shall verify that tomorrow. At the moment that was a good hour's work and I deserve my breakfast!